| OneWire Master |
The OnewWire master (DS2480B based) allows to interface the system with the field modules. IN the properties windows it is possible to specify the port to which the master is attached to or, if the master is connected through an ethernet to serial converter, the IP address of the converter.
| 8 Digital Outputs |
The DO8 is a module that allows to drive 8 digital outputs through a single DS2408 device. The properties window allows to :
- Specify the OneWire ROM address
- Select for each channel if it is normally open or normally close (required to setup the DS2408)
- Specify for each channel if it is used to drive a step relay or a normal relay
- Check the status of the output (0 = open, 1 = close)
- Change the status of the channel
| 8 Digital Inputs |
The DI8 is a module that allows to read up to 8 digital inputs through a single DS2408 device. The properties window allows to :
- Specify the OneWire ROM address
- Select for each channel if it is normally open or normally close (required to setup the DS2408)
- Check the status of the output (0 = open, 1 = close)
| 4 Digital Inputs 4 Digital Outputs |
The IOD4 module allows the user to read 4 digital inputs and to control 4 digital outputs through a single DS2408 device.
The properties windows allows to:
- Enter the device ROM code in reverse byte order
- Setup the input and output channels
- Change the status of the output channels
| Analog Output |
The AO is a module that allows to set a voltage between 0 and 10 Vdc through a single DS2890 device. The properties window allows to :
- Specify the OneWire ROM address
- Set the output value
| Analog Input |
The AI is a module that allows to read a voltage between 0 and 10 Vdc through a single DS2438 device. The properties window allows to :
- Specify the OneWire ROM address
- Read the input value